|
Dual Elevator Ball
Bearing Bell Crank |
 |
Allows the use of one elevator servo to control both
elevator halves.
Servo
drives center arm, outer arms drive elevator horns.
ELIMINATES any differential throw to the elevators
which causes unwanted rolling action. Ball bearings
on each end of the shaft keep action smooth and
friction and slop to a minimum. High strength molded
fittings, suitable for all pattern planes up to
2-meters with rear fuselage thickness under 1-7/16". |
|
|
MKD1231
Fuselage Widths
1-3/16 to 1-7/16 inches
|
$44.99
|
|
MKD1251
Fuselage Widths
1 7/8 - 2 3/16 inches |
$45.97
|
|
 |
 |
Dual Elevator Bell
Crank Allows the use of one
elevator servo to control
both elevator halves. Servo drives
center arm,
outer arms drive elevator horns.
Eliminates
differential throw to the elevators to
prevent
unwanted rolling action. |
|
|
CHS011B Dual Elevator Bell
Crank, 90mm
$18.95
|
|
|
|
|
|
|
Use our lightweight
CARBON FIBER
+ TITANIUM
PUSHRODS
and
MK Control Horn
sets for the BEST setup you can buy! |
|
Central Hobbies
© 1998. All rights
reserved
12/08/11
Click Here for Product or Order Information
|
